I got the idea to build a Hovercraft last year when I read an article about Hovercrafts. From then I studied the topic and wanted to build one for myself. This is my third prototype because the other ones had some issues. For the design I used Autodesk Inventor 2013 and my printer was the MakerBot Replicator. It took around 3-4 days to print the third Hovercraft. The base is not printed because it would take way too long. And Styrofoam has the advantage that it swims when the engines fail. I also did not print the bicycle tubes because they have to be flexible and they must be one piece so that no air flows out to the sides. The Hoveraft is lifted by two motors and it has one thrust motor. The power for the motors comes from three 2800 mAh Lipo batteries. My plans with the Hovercraft are to develop a cheap mobile research station for example for the arctic. The advantages are that it has no CO2 emissions and you can control it from another place like a drone. Just ask if you have a question! Here are two links to articles that have been published: Here is the link for the video: http://youtu.be/Cyb_-NWIL8A I made it wth a Makerbot Replicator Infill: 15% Shells: 2 Speed: 75 mm/s You can find a detailed instruction here: http://makezine.com/projects/3d-print-rc-hovercraft/ You need: Styrofoam base (35” x 14” x 0,8”) Two bicycle tubes (28”), Extra Light (Around 0,31 pound) Two “Hacker A30-12M Brushless Motor” One “Pichler Boost 18 Brushless Motor” Three ESCs “Xetronic 50A” One Servo (Around 4,5 pound pulling load) One receiver and transmitter Hot glue 3x 2800 mAh Lipo batteries with 11,1 Volt 2x Propeller 9x6 1x Propeller 5x4,5 Print all parts once, exept: 2x Ruder 2.1 2x Ruder 2.2 3x Ruder 3x Akku 2x Verkleidung 2.1.4 or 2x Verkleidung 2.1.4.1 and 2x Verkleidung 2.1.4.2 2x Ring 1 2x Ring 2 2x Ring 3 4x Halterung 2x Hubmotor