This is a version of @marianmoldovan's pen holder which removes the text at the bottom. The base has also been thickened somewhat to make the design more bottom-heavy. The mouth requires a 40mm bridge (eyes are 20mm). Since this requires very good calibration, the original version used a support pillar that needed to be cut out afterwards. Included here is a version without the pillar, as well as a version with a support structure that should be easier to detach. It includes .09mm gaps, which theoretically should make an easily detachable support when sliced at .2mm layers (untested). I'm waiting on some green filament to print this. Let me know if there are any problems with the support in the meantime.The unsupported version should be printable if you have well calibrated bridges. The supported version requires much shorter bridges. You might want to inspect the gcode at the top and bottom of the support (Z=40.8 and 58.4mm) to make sure there aren't any gaps.