An add-on clip to hold my Bamboo Stylus on the side of my Motorola Xoom stock cover. I needed some way to keep my stylus with me and realized I had a 3D printer and the case is trimmed in ABS....Voila! A little resin bond and I'm golden. I printed one for a co-worker in the same situation. The nice thing is that in this location the stylus is never in the way and always accessible regardless of the way I have the cover folded.This is designed as a friction fit to the bamboo stylus. I did run some sandpaper around the ID to take down the general roughness of 3D printing (start/stop globs, etc.). I printed it at 0.2 thickness and 100% fill for strength thinking the stylus would snap in and out. Instead it is much easier to just slide it in from the end. Printed on end with a raft to prevent tipping during prints.