This is a fatshark camera mount for a ZMR 250 with customizable camera angle. I needed more camera angle than the usual 10-20 degree which can be found. So this is 30 degree but can be reduced to approx. 10 degree or increased to 35 degree. Does not need any glue to be mounted, its just held in place by the top plate and the plate below. The camera is held with a small zip tie and the bottom plate. The design was inspired by http://www.thingiverse.com/thing:761775 and http://www.thingiverse.com/thing:886877 for the idea with the zip tie. Version 1.1: -tighter fitting so that the camera does not vibrate -changed zip tie position slightly so that the angle can be set between 10 and 35 degree.I printed it in PLA with the following settings on a ultimaker: layer high: 0.15mm shell: 1.2mm infill: 20% bottom/top layer: 0.6mm In order to change the camera angle, open the SCAD file and change the first line "angle" to your camera angle. Render/export/print and have fun. Mount the camera with a small zip tie, there are mounting holes for the zip tie.