About me

I'm a 3d designer with a high attention to detail in my 3d prints. I strive to make sure stringing/ blobs/ warping do not happen on any of my prints.

The photos of the white prints are printed in PLA at 0.08mm and could sit on top of a penny!

My printer can print:

400 x 400 x 450mm
or:
15.7 x 15.7 x 17.7 inches

It is heavily upgraded and is constantly being upgraded every few days currently with with dual fans, X/Y axis tensioners, Z axis stabilizer, extra fans for stepper motor drivers with heat-sinks, a dust collector before extrusion, Capricorn bowden tube, and a filament holder balanced on steel bearings for the easiest of pulling from the filament motor.

My prints will NOT fail mid way and I watch all my prints to the end to make sure they are successful.

If anything goes wrong I correct the issue and reprint for free, I will not send anything out that is not satisfactory.

I heat up all my filaments for 5 hours before printing to clear them of any moisture before printing to get the most crisp of details.