Radio Antenna Replacement Motorola Cls 1410 Custom Design Skeletal





this is a replacement radio antenna cover for a Motorola CLS 1410 walkie talkie radio, one of the most commonly used radios these days. colorful custom look with the curve design and smooth grid of port holes for the skeletal look. Fits tight and secure with some minor user adjustment.
$11.50
Add to cart
this is a replacement radio antenna cover for a Motorola CLS 1410 walkie talkie radio, one of the most commonly used radios these days. colorful custom look with the curve design and smooth grid of port holes for the skeletal look. Fits tight and secure with some minor user adjustment.
Turn on your radio: Press the power button or turn the dial to activate the radio. Access the channel selection: Look for a button or a dial labeled "Tune" or "Frequency" on your radio. This is the control that allows you to navigate through different channels. Set the frequency: Rotate the tuning dial or press the up/down buttons to change the frequency. Channel 0 is often located at the lower end of the frequency range. Keep in mind that the specific location of Channel 0 may vary depending on the radio model and region. Fine-tune the signal: If the radio has a fine-tuning feature, use it to precisely adjust the frequency and improve the reception of Channel 0. This can be especially helpful if the signal is weak or distorted. Confirm the selection: Once you believe you have tuned to Channel 0, listen for any audio or check the radio's display for confirmation. If you don't hear anything or the display does not show any indication of Channel 0, try adjusting the frequency slightly until you find the correct channel. https://www.hamtronics.com/tune-radio-to-channel-0/